

- Mac table lookup for a switch using putty how to#
- Mac table lookup for a switch using putty install#
- Mac table lookup for a switch using putty download#
- Mac table lookup for a switch using putty mac#
Mac table lookup for a switch using putty mac#
Reading the MAC address from left to right, the first six hex digit s refer to the vendor (manufacturer) of this device. When using the ipconfig /all command, notice that MAC addresses are referred to as physical addres ses. On the open dialog, click the “Desktop” tap and then “IPĬonfiguration” box to configure the PC’s IP address information according to the Addressing Table: In Packet Tracer, click PC-A (do the same for PC-B after). Configure the IPv4 address, subnet mask, and default gateway address for PC-A and PC-B according to the

*Mar 1 00:07:59: %SYS-5-CONFIG_I: Configured from console by console Step 3: Configure the IPv4 addresses for the PCs. Configure and enable the SVI interface for VLAN 1.
Mac table lookup for a switch using putty how to#
How to console into the switch: Connect to the switch S2’s Console port using a serial console cable from PC-BĬommunication port, and open PuTTy on the desktop of PC-B (connect via Serial). Console into the switch and enter global configuration mode. In this step, you will configure the device name and the IP address, and disable DNS lookup on the switch S2. *Mar 1 00:07:59: %SYS-5-CONFIG_I: Configured from console by console Step 2: Configure basic settings for the switch S2 . Assign a hostname to the switch based on the Addressing Table. Power on all the devices in the topology.īuild the network as shown in the Topology using Packet Tracer.įrom the bottom-left Device Box, choose “Network Devices” -> “Switch-PT” -> “ 2960 ” and drag the switch to yourĮnter configuration commands, one per line. Attach the devices shown in the Topology and cable as necessary. Step 1: Cable the network as shown in the Topology. Such as the interface IP addresses on the router and PCs. In Part 1, you will set up the network topology, clear any configurations, if necessary, and configure basic settings, You will see the Cisco PacketĪ tutorial of Packet Tracer can be found here static-pt-assets.s3.amazonaws/tutorials72.htm Part 1: Set Up the Topology and Initialize Devices

Mac table lookup for a switch using putty install#
Install the Packet Tracer, Open the Packet Tracer and Log in with your account.
Mac table lookup for a switch using putty download#
Download CISCO Packet Tracer 7.3 fitting your systemĭevice Interface IP Address Subnet Mask Default Gateway Go to netacad/ and create an account.ī. Part 1: Get familiar with Cisco Packet Tracer Step 1: Register CISCO accountĪ. Part 5: Use the IOS Show ARP Command Required Resources Part 4: Display, Describe, and Analyze Ethernet MAC Addresses Part 3: Configure Devices and Verify Connectivity Part 2: Set Up the Topology and Initialize Devices Part 1: Get Familiar with Cisco Packet Tracer Week 2 Lab – Observing MAC Addresses and ARP Topology Addressing Table Objectives
